Visor shield purple to the Bell 1:2 scale mini helmets

The purple visor shield is designed for helmets from the manufacturer Bell in a scale of 1:2. Its recommneded only for Bell mini helmets from 2019 season till present (in other case the shield will not suit to other mini helmet brand or past releases).

It is an aesthetic accessory so that your helmet gets as close as possible to the real helmets of F1 drivers.

It is primarily intended for helmets with the code HP77.

The package consists of 1 shield.

For the correct application read the enclosed written information.

Shield installation in few steps: 

- Remove the original visor by releasing two screws on the right side and the left side (Hex key and screwdriver is required)
- Carefully remove the screws and pads
- Put the new visor on the helmet, insert the original screws into the appropriate holes and pull on both sides.
- If the original visor had a self -adhesive visor tape designed for a given helmet, you can peel it off and then put it to the new visor. When peeling off 
the original tape should be cautious as careful as the tape can tear, stretch and wrap.

It is recommended to clean the visor only with a soft microfiber cloth. It is forbidden to use chemical liquid cleaners or other aggressive products.